Xtra Bond Windshield Repair
Adhesion Promoter
Xtra Bond (patent pending) is the first and
only adhesion promoter for windshield repair. Xtra Bond will allow windshield repair adhesives to have a greater bond to the
windshield glass by etching and priming the surface of the crack(s).
Directions for a
stone break: Use a windshield repair tool to inject and fill the break with Xtra Bond. Allow to evaporate which will usually take
one to five minutes depending on humidity, ambient temperature and the
temperature of the glass. The warmer the temperature the faster it will
evaporate. If it is not evaporated in five minutes use a heat gun or blow dryer
for five seconds. You can also use a heat gun or blow dryer anytime after it
has been in the break for 90 seconds. Placing your tool in the vacuum mode will
speed evaporation. Wipe off excess on windshield surface immediately. You can also
place a drop on a Q-Tip and press it on the impact point, which will cause it
to fill by capillary action on some breaks.
Directions for a
crack: Inject by capillary action for vertical cracks and by injector slide
for horizontal cracks. We also recommend
you prime the edge area (the four inches from the edge) of an edge crack with
primer resin after the Xtra Bond has evaporated. Wipe
off excess on the windshield surface immediately.
Directions for the Pit only: Place a drop above the
pit and allow it to roll into the pit before doing the repair. Allow to completely
evaporate including any chemical that seeped into the break. Wipe off excess
immediately.
Purchase Price: One bottle for $39.95 will
decontaminate over 100 breaks.
